Combines, in parallel echo and reverb effects, Coldcraft Effects EchoVerberator
This pedal is not ordinary echo, reverb.
Coldcraft Effects EchoVerberator is the effect, combined with ECHO and reverb in parallel.
Also can induce at separate delay and reverb, echo or reverb, is repeated reverb is not.
You can make clear and clean sound mixing additional effects.
Reverb-side is based on a lush room style reverb.
Ecocide is warmth, characterised by an organic repeat repeat repeat, delay time-dark tone.
It is also switching the tape echo style modulation.
■ a rich reverb and echo
■ reverb always ON mode.
■ momentary mode
■ a standard Center minus 9 VDC adapter drive
■ upgrade program available
< Trail with buffardbypass >
Includes the EchoVerberator plus low noise IMP and stage the Opamp output stage, a unique hybrid PRI amp.
This preamplifier is maintains full signal range out to the amplifiers and sound engine in both.
Auxiliary audio signal in this buffardbypass it is very likely that the reverberation effect is usually placed at the end of the effects Board, also function as the pedalboard outputbuffa, to travel to long cable from there.
Leave the reverberation in the bypass trail (seamless/reverb) works in all modes.
< Analog drips >
Obtained to keep the dry signal is pure EchoVerberator is based on a powerful DSP effects, analog signals, because the dynamics and responses to the analog drips structure.
< Mode Reverb Always-On >
Dual-DIP switch internal to EchoVerberator.
Switch 1 a Reverb Always-On's (reverb always ON) mode.
To turn ON this mode, and in effect bypassing reverb to take will be.
In this mode, only assigned echo effect on/off footswitch.
(The trail to bypass)
< Not-so-Tape mode >
Switch to reproduce the tape echo sound original echo program switch another DIP suit and tape programs.
In this mode light modulation, input signal takes soft compression with dynamic filter algorithm.
Timbre reminiscent of Wow and flutter effect reminiscent of the Echoplex EP-3 and pre-amp effects.
< Momentary Bypass mode >
You can EchoVerberator to the momentary mode.
While in this mode, being stepped on the foot switch will take effect.
In momentary mode to enter first 3 seconds or more effects to bypass State and the press by tap, tap and hold the foot switch (2 times after you tap and hold and).
This LED blinks, indicates the mode switch. This mode may also be used in conjunction with the Always-On Reverb mode.
In that case, takes a delay takes always to reverb, while stepping on the foot pedal.
Unplug the power cord once to return to the original mode and plug it again.
(This mode will not be saved. )
< Controls and how to use >
• Dwell: adjust the length of the reverb.
-Time: adjusts the delay time.
-Repeats: adjust delay feedback.
• Reverb: adjusts the reverb level.
-Echo: adjusts the level of the ECHO and delay.
First of all, all the knobs and set to 12, with Reverb and Echo knob sets the effect level for each.
After the Dwell Time, Repeats knob to use the advanced sound effects.
-Input Impedance: ~ 500 k Ω
-Output Impedance: ~ 1 k Ω
● Current Draw: < 60 mA
[Available] [Fun tomorrow] notation items other than the basic inventory on.
On request a manufacturer dependent items next day shipping is available.
(However: manufacturer stocked items and on weekdays in manufacturers orders time)
* May no longer reflect the commodity status in real time.
Please note that when sold out.