-Elimination of printed circuit board
It is a signal that does not use any printed circuit board arrangement method. Best wire now possible with one selection depending on the circuit, is wired. Small signal amplification faithfully without losing any amount of information, without having anything.
-Separate she she structure of high rigidity
On the chassis used in the heavyweight main adopts a 1.6 mm thick steel plate, preventing the oscillation of the inside and outside. Amplifier where the copper plating, as a non-magnetic magnetic distortion to prevent.
-Use of high-quality and high-precision volume
● low noise power supply
Small signal Equalizer amplifier, low noise is required. High voltage power supply circuit is operating speed is faster than Silicon diodes, Rectifier tubes and no pulse. Is a thoroughly low-noise design through the vacuum regulator circuit after filtered by semiconductor, through the capacitor banks for high-capacity, is supplied to each amplifier.
Two-stage NF system, outputs adopted SRPP circuit high output with low impedance. NF circuit for broadband, stable and driven low promotes distortion.
-Boost voltage transformer with
Use tube: 12AX7 (ECC83) x 3, 12BH7 x 1, 6 X4 x 1, 6267 (EF86) x 1, ECC88 x 2
Output voltage: rated 2 V up to 20 V
Output impedance: 2 k Ω
Total harmonic wave distortion:0.08% below (2.5V, 1 kHz)
Frequency response: 5-100000 Hz (± 1.5dB)
(IHF-A corrected) s/n ratio: more than 78 dB (phono), more than 97 dB (line)
Dimensions: power of 400 x 340 x 120 mm (WxDxH)
Amp 400 x 340 x 150 mm (WxDxH)