[Manufacturer] OMRON (Omron Corporation)
[Category] solid state timer
[Format] H 3YN-4
Type a short time select the time specification (0.1 s-10 min)
Number of Poles, 4 c
Note.-H3YN, socket and retention bracket are included
[Form] form H 3YN-2 /-4
Short time select the time specification type 0.1 s ~ 10 min (1 s, 10 s, 1 min, 10 min 4 range switching)
[Power supply voltage * 5 * 6], DC12V, DC 24 V DC48V, DC 100-110 V-DC125V * 2
Switch dip switch 4 mode [mode] delay-on de-energisation, flick of the start interval and Frick on start
85 to 110% of the permissible voltage fluctuation range supply voltage (however only DC12V power supply voltage 90 ~ 110%) * 3
The power consumption (for reference only)]
DC12V relay OFF time approximately 0.1 W: relay on approx. 1.1 W (when the DC12V)
DC24V relay OFF time approximately 0.1 W: relay on approx. 1.1 W (when DC24V)
DC100-110 V when the relay is OFF about 0.4 W: relay on approx. 1.6 W (when DC110V)
Less than 10% of the recovery voltage power * 4
2: AC250V5A resistive load (cos φ = 1)
The minimum applied load DC5V1mA (P level, reference)
Contact material: Ag
Quadrupole: AC250V3A resistive load (cos φ = 1)
/ 3YN-4-H-41: the minimum applied load DC1V1mA (P level, reference)
-H3YN-4-Z / - 41-Z: minimum applied load DC1V0. 1 mA (P level, reference)
Contact material: Au clad + Ag alloy
Ambient temperature-10-+50 ° C (However, no freezing)
The storage temperature-25-+65 ° C (However, no freezing)
Ambient humidity 35 ~ 85%
* 1. Inverter output, do not use as a power source.
* 2. Single phase full wave rectifier power supply is available.
* 3. At ambient temperature 50 ° C continuous use time is 95 to 110% (DC12V) 90-110% of the power supply voltage please.
* 4. To get back to ensure DC10V below please AC20V, 100-110 V DC AC10V, AC 200-230V AC 100-120 V.
* 5. See the maker's catalog when you use it in combination of AC two-wire proximity sensor and timer.
* 6. Is the power supply voltage with inverse Ki blocking diode DC type only.
[Form] form H 3YN-2 /-4
Variation of time ± 1% or less (maximum season-at) (1 s range is ± 1% ± 10 ms or less)
[Set error, ± 10% ± 50 ms or less (maximum season between)
Resume time 0.1 s or less (including on the way back)
On the influence of voltage ± 2% or less (maximum season while at)
On the influence of temperature ± 2% or less (maximum season while at)
Insulation resistance 100 M Ω or more (500 V menu moths in the measure)
AC2, 000 V 50/60 Hz 1min conductive power of terminals and exposed non-charging of intermetallic, except for screw terminals)
AC2, 000 V 50/60 Hz 1min (operation power supply circuit and output between)
AC2, 000 V 50/60 Hz 1min (between 2 different contact type)
AC1, 500 V 50/60 Hz 1min (different pole contacts between the 4-pole type)
1,000 V 50/60 Hz 1min (between the non-contiguous contacts)
Durable 10-55 Hz single amplitude 0.75 mm each 1 h 3-way
10-55 Hz malfunctioning piece amplitude 0.5 mm 3-way each 10 min
Durable 1000 m / s 2 6 direction 3 times
Malfunctioning 100 m / s 2 6 direction 3 times
Mechanical 10 million times more (no load, opening and closing frequency 1800 times/h)
2-pole electrical more than 500000 (AC250V5A resistive load switching frequency 1800 times/h) (at room temperature)
4-pin (z is more than 100000) than 200000 (AC250V3A resistive load switching frequency 1800 times/h) (at room temperature) *
Impulse voltages between the power supply terminals 3 kV, however DC12V, DC24V, DC48V, AC24V, 1 kV, conductive power of terminals and non-rechargeable metal between 4.5 kV and exposure however, DC12V, DC24V, DC48V, AC24V 1.5 kV.
Noise bearing noise Simulator using square wave (pulse width 100 ns/1 μ s rise 1 ns) ± 1.5 kV
[Static strength, 4 kV (malfunction) 8 kV (destruction)
The protection structure IP40
[Mass] approximately 50 g