|Name of product|
|How to use|
|1. put the foam nozzle into hole in top of foam master and fit securely to the base.
2. remove the bottom foam master body to thin soda cartridges on put holder, adjust up and down.
3. ensure that gas out with foaming nozzle, press the push button.
4. plug the nozzle with a foam Tip 1 cm or so beer and poured into a glass, press the push button only one time.
Put foam in good tips
（ to Jet around, rather than the center of the glass near the edge of the glass, and can make adequate amounts of foam. In addition, beer and glass chill's. In the summer, about five to seven degrees is optimum. ）
* Finished foam master, remove the nozzle, let dry and wash.
|Soda cartridge replacement|
|When the gas supply is stopped press the push-buttons replacing ink cartridges.
If you slowly turn the holder body relax, and gas emission sound cut off gas from slowly loosen. Rapidly removing mightily out carbon dioxide from gas relief holes of the holder could cause frostbite. Gasket is damaged and can no longer be used.
* From used soda cartridges, verify that the open hole sealing plate (lid), follow the instructions in each municipality. Material: steel
|Approx. 65 g （ cartridges mounted at approximately 100 g ）|
|Body (ABS, aluminium), nozzle (P. P.), and soda cartridges (iron)|
|Please note that|
|This product cannot compensate for flat beer and carbonated. To make bubbles in beer and fluid causing shock in carbon dioxide from liquid carbon dioxide out.|
|Product feature list|
|Foam master: foam: foam: millet: beer: beer malt: second: third beer non-alcoholic beer: silky foam: fine: detailed: drinking spout sleek shop beer: home, and beer: carbon dioxide ：CO 2: taste: mellow: telemarketing, mail order: sales: buy: buy: shop: selling: shopping|
|048-551-7965 pulse advertising prepared by (aerobic)
Start Date:01/07/2015 00:00 JST
End Date:31/07/2015 23:59 JST
This product cannot be shipped to United States from the store.
Please contact the store for further information.